P2ABE
Turbocharger/Supercharger Wastegate Actuator B Driver Current/Temperature Too High
P2ABE is the turbo B counterpart of P2ABD: the output stage driving the second electric wastegate actuator signals overcurrent or thermal overload. It therefore applies only to twin-turbo engines with two electric actuators, such as Ford's EcoBoost V6. Ford's summary treats it together with P0247 as the B circuit check, with the fault detected inside the smart driver chip and a monitoring time of 0.4 s; the functional checks P25B5/P25B6 are blocked while either code is stored. No public bulletin naming P2ABE turned up. A rod seized by corrosion, a shorted motor winding or a harness pinched against the turbo can make the driver shut down to protect itself. Because the bank 2 flap is then left unpositioned, the PCM is likely to limit boost on that side.
Possible causes
- Wastegate B rod or flap seized by corrosion or heat high
- Shorted winding in electric actuator B medium
- Actuator harness pinched against the turbocharger medium
Symptoms
- Check engine light on
- Reduced power, uneven boost between the two banks
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2ABE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.