P2ABD
Turbocharger/Supercharger Wastegate Actuator A Driver Current/Temperature Too High
P2ABD is raised by the output stage that powers the electric wastegate actuator of turbocharger A when it detects excessive current or overheating. Ford's 2020-23 gasoline summary groups it with P0243 in the wastegate A circuit check: the PCM's smart driver chip recognises a short to battery or ground and an open load on its own and reports within 0.4 s, and the stuck open/closed tests P25B3/P25B4 are only allowed when neither code is present. No Ford bulletin naming P2ABD was found. GM runs a comparable self-protection check on the EGR cooler bypass motor (P2AA5, H-bridge above 170 °C). A linkage that binds and stalls the motor, an internally shorted motor or chafed supply wires make the driver protect itself. P2ABE is the same fault on turbo B.
Possible causes
- Wastegate flap or rod binding from soot, corrosion or heat so the motor stalls high
- Electric actuator motor shorted internally medium
- Actuator supply wires chafed to ground or to each other medium
- Driver stage in the PCM faulty low
Symptoms
- Check engine light on
- Clearly reduced power because the wastegate is no longer driven
- Stuck wastegate checks P25B3/P25B4 not run while the code is stored
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2ABD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.