P2ABC
Wastegate Position Sensor B Circuit High
P2ABC is the high-voltage fault on the wastegate B position sensor: according to Ford's 2020-23 gasoline summary the input sits above 4.50 V for 4 s, a picture typical of a signal line shorted to the reference supply or an open sensor ground. On the 2.7L F-150 of model years 2021-22 Ford blames false P2ABC entries on calibration and fixes them by reprogramming the PCM (TSB 22-2357); TSB 23-2353 and SSM 54083 add it for the 3.5L V6 in F-150 and Expedition/Navigator. Since the driver cannot tell a sensor fault from a sticking flap, both show up as lower power or a fault light. Heat and vibration at the turbine housing loosen terminals, so the actuator connector deserves the first look. P2ABB is the low side, P2AB9 the same fault on turbo A.
Possible causes
- PCM calibration that sets the code falsely (Ford reflash for listed models) medium
- Open sensor ground or heat-damaged terminal at the actuator medium
- Signal wire shorted to the reference supply or battery voltage medium
Symptoms
- Check engine light, on Ford possibly the wrench indicator
- Reduced power under load
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2ABC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.