P2ABB
Wastegate Position Sensor B Circuit Low
P2ABB reports that the position signal of the turbocharger B wastegate is too low, as a short to ground, a broken signal or supply wire or a failed sensor would cause. Ford's 2020-23 gasoline summary applies the same window as for turbo A and sets the code below 0.50 V after 4 s. In that document the threshold line for this sensor names sensor A, evidently an editing slip, since the heading and code title both refer to B. Ford lists P2ABB in TSB 23-2353 and SSM 54083 for twin-turbo applications such as the F-150 3.5L and Expedition/Navigator. The two GM tables reviewed here (2019 L3B, 2025) contain only the A codes. On a V6 the bank 2 flap can then no longer be positioned, so expect reduced boost and power. High is P2ABC, the bank 1 counterpart P2AB8.
Possible causes
- Sensor wire chafed to ground near the bank 2 turbocharger high
- Open reference supply or signal wire, loose connector medium
- Position sensor in wastegate actuator B failed medium
Symptoms
- Check engine light
- Less power, especially when accelerating hard
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2ABB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.