OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2AB8

Wastegate Position Sensor A Circuit Low

P2AB8 means the wastegate A position signal has fallen below its valid floor, which points to a short to ground, an open signal or reference wire, or a dead sensor. GM's 2019 tables for the 2.7L L3B read the sensor as a percentage of its reference and fail below 5 % in 30 of 38 samples taken every 100 ms; the 2025 tables use below 1 % in 10 of 12. Both run only outside cranking with powertrain relay voltage of at least 11 V and are Type A, so the lamp lights in the first trip. Ford's 2020-23 gasoline summary sets it under 0.50 V after 4 s. Stellantis case S2308000121 traces P2AB8 with P0245 on the Jeep Wrangler to a pinched harness between turbo and intake hose. P2AB9 is the high side, P2ABB bank 2.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / B8

Possible causes

  • Sensor harness pinched or chafed between turbocharger and intake hose (short to ground) high
  • Open reference or signal wire, or pushed-out terminal in the actuator connector medium
  • Position sensor inside the electric actuator failed medium

Symptoms

  • Check engine light from the first trip
  • Reduced power because boost control is restricted
  • May appear together with P0245 when a shared harness section is damaged

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2AB8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication