OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2AB6

Cold Start Intake Manifold Runner Control Stuck Closed Bank 2

P2AB6 reports the runner flaps of bank 2 held in the closed position during the cold-start phase, against a command to open them. Like its siblings it exists only on engines that control each bank's runners separately and only becomes testable after a soak of six hours or more at ambient temperatures from -6.7 °C upward, as defined in CARB's cold-start rules. No manufacturer documents P2AB6 publicly. Ford's gasoline summary for 2020 to 2023 lists the everyday equivalent as P2007 and treats plates that miss the commanded position or overrun their travel as a functional fault. Because only one bank is restricted, the engine may run slightly unevenly between the banks until the flaps free up or the strategy ends. If P2AB5 is set as well, suspect a shared actuator supply. P2AB4 is the open-stuck case on this bank.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / B6

Possible causes

  • Bank 2 flaps seized by deposits or ice high
  • Bank 2 actuator or its control valve defective medium
  • Shared actuator supply or vacuum source weak (often with P2AB5) low

Symptoms

  • Check engine light on
  • Slightly uneven running and reduced pull after a cold start
  • Higher cold-start emissions

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2AB6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication