OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2AB5

Cold Start Intake Manifold Runner Control Stuck Closed Bank 1

P2AB5 is the opposite of P2AB3: during cold start the runner control on bank 1 remains in its closed position and does not follow a command to open. CARB requires, for 2026 to 2028 phase-in vehicles, that such valves react measurably and in the commanded direction while the cold-start conditions hold, meaning a soak of six hours or more and coolant close to ambient. A flap that stays closed throttles the air path once the engine is asked for more load, so a lack of pull in the first minutes is possible, and the combustion pattern the calibration expects for the cold catalyst is lost. No manufacturer documents P2AB5 publicly. Ford's conventional counterpart outside the cold-start phase is P2006, judged against the commanded plate position. Bank 2 is P2AB6.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / B5

Possible causes

  • Flaps stuck closed by deposits or condensate freezing at low temperature high
  • Actuator motor or vacuum valve does not move the shaft medium
  • Broken return spring or worn shaft bushing low

Symptoms

  • Check engine light on
  • Less power in the first minutes after a cold start
  • Higher cold-start emissions

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2AB5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication