OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2AB4

Cold Start Intake Manifold Runner Control Stuck Open Bank 2

P2AB4 is the bank 2 version of the open-stuck check during cold start, so it only appears on engines with a separate runner control for each cylinder bank, typically V or flat engines. The runner flaps of the second bank fail to leave their open position as long as the cold-start routine runs, so that bank burns its mixture with less charge motion than intended. No manufacturer documents P2AB4 publicly; the requirement comes from CARB's cold-start component monitoring, which only applies once the engine has been off for six hours or longer. Ford's 2020 to 2023 gasoline summary shows the conventional split for vacuum-actuated V engines, with P2004 for bank 1 and P2005 for bank 2. Comparing bank 2 with bank 1 helps: if only one side lags, look at that actuator, its vacuum line and its linkage. Bank 1 is P2AB3.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / B4

Possible causes

  • Leaking vacuum line or diaphragm on the bank 2 actuator high
  • Bank 2 flap shaft stiff from deposits medium
  • Electric actuator for bank 2 defective medium

Symptoms

  • Check engine light on
  • Uneven running between the banks shortly after a cold start
  • Higher cold-start emissions

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2AB4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication