OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2AB3

Cold Start Intake Manifold Runner Control Stuck Open Bank 1

P2AB3 is part of the cold-start component checks that CARB phases in for 20, 50 and 100 percent of new vehicles in 2026, 2027 and 2028. Right after a start that follows a long standstill, charge motion, runner and swirl valves must follow the cold-start command clearly, toward the target and further than they would at a start without that strategy. The test only counts after at least six hours off, at -6.7 °C or warmer, with coolant no more than 15 °C above ambient. P2AB3 means the runner control on bank 1 stays in its open position when the cold-start strategy calls for a change. No manufacturer documents P2AB3 publicly. For comparison, Ford's ordinary IMRC check runs continuously above 40 °F coolant and judges stuck plates after 4 events (P2004). Weaker mixture motion raises cold emissions.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / B3

Possible causes

  • Actuator or vacuum unit too weak to move the flaps when cold high
  • Flap shaft stiff from carbon or oil deposits medium
  • Linkage detached or broken between actuator and shaft medium

Symptoms

  • Check engine light on
  • Rougher idle in the first minutes after a cold start
  • Higher cold-start emissions, otherwise often unnoticed

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2AB3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication