P2AB0
Particulate Matter Sensor Processor Performance
P2AB0 concerns the electronics of the particulate matter sensor rather than its sensing element: the sensor control unit, which feeds the electrodes, measures their current and reports over CAN, finds an internal error in its own measuring path. GM's 2025 diesel tables (25OBDG04A and B) describe it as an internal fault of the current switcher: the electrode current read in the small range must lie between a minimum and a maximum, tested while the sensor is regenerating, with its bus relay on and no CAN or electrical faults present; Type B, two trips. Bulletin KC-2080 for Mack and Volvo trucks adds that on PM sensors built before the end of 2017, P2AB0 logged together with U0080 points to a CAN fault rather than the sensor itself. Lost communication is U02A3.
Possible causes
- Internal fault in the PM sensor control unit (sensor and control unit usually replaced as one part) high
- CAN wiring fault that older sensor versions also report as P2AB0 medium
- Unstable supply or ground at the sensor control unit low
Symptoms
- Check engine light on
- Particulate filter monitoring cannot complete
- Driving behaviour usually unchanged
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2AB0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.