P2AAA
Engine Coolant Bypass Valve B Position Sensor Circuit High
With P2AAA the position sensor of coolant valve B reports a value above anything a working sensor would deliver. Typical reasons are a signal line touching a supply wire, a damaged output stage inside the sensor or, depending on how the input is wired, an interrupted ground. Since the engine computer can no longer tell where the valve really stands, it loses closed-loop control and has to rely on a fixed default position. No manufacturer documents P2AAA publicly. GM's code for the comparable valve C, P23C5, flags a SENT value above 4,050 counts, again over 4 of 5 seconds and as Type B, and names a short to power as the cause. CARB requires input components to be checked for wiring faults and for readings beyond their limits. P2AA9 is the low counterpart, P2AAB the sporadic one.
Possible causes
- Signal wire in contact with a supply or reference voltage wire high
- Sensor ground open at the connector or splice medium
- Position sensor in the valve module defective medium
Symptoms
- Check engine light on
- Coolant temperature swings or stays off target
- Possibly reduced engine power if the module protects against overheating
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2AAA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.