P2AA9
Engine Coolant Bypass Valve B Position Sensor Circuit Low
P2AA9 is set once the position sensor on coolant valve B reports a value below its valid band, which nearly always means the signal wire or the sensor output is pulled toward ground. Rotary coolant valves in thermal management modules report their angle so the engine computer can steer coolant between radiator, heater and other loops. No manufacturer documents P2AA9 publicly. GM's 2025 diesel tables list the matching check for valve C as P23C4: the SENT reading has to drop under 27 counts for 4 of 5 seconds, rated Type B with two trips, and the test only runs while SENT communication itself is healthy. Ford, by contrast, gives the letter B to a transmission cooling valve without position feedback. The high-side fault is P2AAA.
Possible causes
- Sensor signal wire chafed through and shorted to ground high
- Position sensor electronics in the valve module failed (often only as complete valve unit) medium
- Coolant or moisture in the sensor connector creating a leakage path to ground low
Symptoms
- Check engine light on
- Engine warms up slowly or runs cooler than usual
- Cabin heating or transmission warm-up weaker, depending on what valve B serves
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2AA9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.