OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2AA5

EGR Cooler Bypass Control Circuit Driver Current/Temperature Too High Bank 1

P2AA5 comes from the H-bridge that drives the DC motor of the bank 1 EGR cooler bypass flap: the driver chip itself reports that it is getting too hot. GM's diesel summary tables carry this monitor from 2017 (17OBDG04) to 2025 (25OBDG04A) as a motor overtemperature check. The fault flag comes from the hardware layer when the bridge exceeds 170 °C; the test runs outside cranking with powertrain relay voltage above 11 V, needs 160 failures in 200 samples at a 12.5 ms task and is Type B. GM bundles it with the open and shorted circuit codes P245A, P245C and P245D as an actuator fault. A flap that binds on soot, a motor with internal damage or a partial short make the bridge work too hard. A flap stuck in one position is P24A5; bank 2 is P2AA6.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / A5

Possible causes

  • Bypass flap binding on soot or corrosion, motor working against resistance high
  • Internal fault in the bypass actuator motor medium
  • Partial short between the motor wires medium
  • Overheating or faulty H-bridge in the engine control module low

Symptoms

  • Malfunction indicator lamp on after two trips
  • Bypass flap no longer driven, so warm-up EGR cooling stays at its last state
  • Possible further EGR or cooler efficiency codes

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2AA5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication