OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2AA1

Alternative Fuel Return Line Valve Control Circuit High

P2AA1 is the opposite electrical case to P2AA0: the valve drive wire sits at too high a voltage, usually because it touches a battery-fed wire. Where the module switches the ground side, as in the ROUSH CleanTech Gen 4 propane system with its relay-module ground, a line stuck at supply level leaves no voltage across the coil, so the valve cannot be energized at all and stays in its rest position. When the module then turns its transistor on, it may also see an overcurrent and shut the stage off. A wire nipped between harness bundles or a coil whose winding has shorted to its supply pin are the usual finds. Public manufacturer documentation for P2AA1 does not exist; CARB requires output circuit faults to be flagged.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / A1

Possible causes

  • Control wire shorted to a battery-fed wire in the harness high
  • Solenoid winding shorted to its supply terminal medium
  • Bent or bridged pins in the valve connector medium
  • Output stage in the fuel control module shorted internally low

Symptoms

  • Malfunction indicator lamp on
  • Return valve cannot be switched and stays in its rest position
  • Poor hot starts or switch to the base fuel

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2AA1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication