OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2AA0

Alternative Fuel Return Line Valve Control Circuit Low

P2AA0 means the module reads too low a voltage on the control line of the return line valve, which almost always points to a short to ground. What follows depends on which side the module switches. In the ROUSH CleanTech Gen 4 propane layout the valve has a fused battery feed and its ground wire runs to a relay module; if that ground wire chafes against the frame, the coil is energized whenever the supply is live and the valve can no longer be closed. With a high-side driver the same short would instead blow the fuse or make the driver shut down. No manufacturer documents P2AA0 publicly, and CARB only requires that such output faults be detected. Check the harness along the tank and frame first, then the coil.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / A0

Possible causes

  • Control wire chafed through and touching the frame or tank high
  • Water in the valve connector bridging to ground medium
  • Internal short in the solenoid coil medium
  • Damaged output stage in the fuel control module low

Symptoms

  • Malfunction indicator lamp on
  • Return valve stays open or the valve fuse blows, depending on the circuit layout
  • Irregular rail pressure or switch to the base fuel

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2AA0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication