OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A9F

Alternative Fuel Return Line Valve Control Circuit Range/Performance

P2A9F covers the grey zone between a clean open and a clean short: the control circuit of the return line valve is connected, but the current or voltage the output stage measures while driving it does not fit the command. Typical reasons are a coil whose resistance has drifted, a few shorted windings, or high contact resistance in a corroded connector that lets the coil pull in only weakly or late. For a comparable tank solenoid the ROUSH CleanTech propane manual gives 6 to 35 ohms as the acceptable window, which is a useful benchmark when measuring. No manufacturer documents P2A9F or a threshold for it publicly. A valve that switches unreliably can leave vapor in the rail after a hot soak; a hydraulic lack of return flow with a sound circuit is P2AA2.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 9F

Possible causes

  • Solenoid coil resistance out of range or partially shorted windings high
  • High contact resistance from corrosion or water in the connector medium
  • Low supply voltage at the valve from a weak relay contact or ground medium
  • Output stage of the fuel control module measuring incorrectly low

Symptoms

  • Malfunction indicator lamp on
  • Occasional hard starts after a hot soak
  • Fault comes and goes with temperature or moisture

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2A9F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication