OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A9E

Alternative Fuel Return Line Valve Control Circuit/Open

Liquid-phase propane and LPG systems pump more fuel to the rail than the injectors use; the surplus flows back to the tank and carries heat and vapor away with it. A return line valve opens or blocks that path. With P2A9E the drive circuit of this valve is open or broken in some other way, so the module can no longer switch it and the valve rests in its unpowered state. The ROUSH CleanTech Gen 4 propane manual for Ford trucks shows what such a circuit looks like: a solenoid on the tank with a coil of 6 to 35 ohms, fed with battery voltage through a 10 A fuse and a relay, its ground side run to a relay module. Roush files its solenoid faults under other codes, and no manufacturer documents P2A9E publicly; CARB demands continuity checks on output circuits.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 9E

Possible causes

  • Corroded, wet or loose connector at the tank-mounted valve high
  • Broken wire in the frame or tank harness medium
  • Open solenoid coil in the return valve medium
  • Blown fuse or faulty relay in the valve supply medium
  • Failed output stage in the fuel control module low

Symptoms

  • Malfunction indicator lamp on
  • Hard or long cranking on a warm engine, as vapor is not flushed out of the rail
  • Switch to the base fuel or reduced power on bi-fuel or dedicated systems

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2A9E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication