OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A9C

Alternative Fuel Tank Select Valve C Control Circuit High

P2A9C reports a control voltage at select valve C above the level the commanded state permits. The usual reasons are an interrupted coil or wire on a valve the module switches to ground, which leaves supply voltage on the line, or a foreign voltage fed in from a damaged neighbouring wire. Valve C then ignores commands. In a staged strategy like the one Cespira patented, where the controller moves between supplies as their pressures drop below set limits, the step involving vessel C is lost, so its content is either never tapped or cannot be shut out of the sequence. Range falls and the engine may switch to its other fuel sooner. No manufacturer publishes P2A9C. Compare coil resistance with valves A and B where they are identical.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 9C

Possible causes

  • Open coil or wire on ground-switched valve C high
  • Foreign voltage from a damaged neighbouring wire medium
  • Corroded terminals at valve C low

Symptoms

  • Malfunction lamp on
  • Third vessel never drawn, range reduced
  • Earlier change to the other fuel

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2A9C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication