OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A98

Alternative Fuel Tank Select Valve B Control Circuit High

P2A98 appears when the voltage on the control circuit of tank select valve B stays higher than the module allows for the commanded state. A ground-switched valve with an interrupted winding or lead shows this pattern, as does a wire that has picked up battery voltage. The valve will then not move on command, and the system keeps drawing from whichever vessel the resting valve connects. In Westport's two-vessel design with a single pump, that means one tank is used up and the second is never reached, so the engine runs short of gas while the gauge still shows reserve. CARB's heavy-duty rule expects such circuit faults to be detected and stored separately. No manufacturer publishes P2A98. A coil resistance check at the valve plug separates a dead coil from a wiring fault.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 98

Possible causes

  • Interrupted winding or lead at valve B high
  • Control line of valve B in contact with battery voltage medium
  • Corrosion at the valve B connector raising resistance low

Symptoms

  • Malfunction lamp on
  • Second vessel never used, gas runs out early
  • Gauge shows reserve while power drops

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2A98

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication