OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A97

Alternative Fuel Tank Select Valve B Control Circuit Low

P2A97 indicates that the drive line of tank select valve B reads too low. If the module feeds the valve from the positive side, a short to ground in the wire or a coil with shorted windings drags the output down, and the stage switches off to protect itself, so valve B falls back to its spring position. If the module switches the ground side instead, the same short can hold the valve energised all the time. The practical effect is that the choice of vessel no longer follows the strategy: in the staged scheme Cespira patented for two gas supplies, the controller cannot react when a supply reaches its lower pressure limit. No manufacturer documents P2A97. Look for chafing where the harness crosses tank straps and brackets. P2A98 is the high counterpart.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 97

Possible causes

  • Wire to valve B chafed against a tank strap or bracket high
  • Shorted windings in the coil of valve B medium
  • Moisture bridging the pins of the valve B plug low

Symptoms

  • Malfunction lamp on
  • Tank change does not happen or happens at the wrong time
  • Gas mode ends early with fuel still on board

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2A97

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication