OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A94

Alternative Fuel Tank Select Valve A Control Circuit High

P2A94 reports a control voltage at tank select valve A above what the module expects for the commanded state. On a valve switched to ground by the module, an open coil or broken lead leaves the line floating at supply voltage; alternatively a chafed wire contacts a battery feed that the output stage cannot pull down. Either way, valve A does not respond to commands and stays wherever its spring or the foreign voltage holds it. In the staged two-supply strategy patented by Cespira, the controller then cannot move to the second supply when the first falls below its threshold, or cannot leave it. Range shrinks or the engine falls back to its other fuel. No maker publishes P2A94. Check coil resistance, then the harness to the valve.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 94

Possible causes

  • Open coil or broken lead on a ground-switched valve A high
  • Control wire of valve A touching a battery feed medium
  • Corroded pins with high resistance at valve A low

Symptoms

  • Malfunction lamp on
  • No change to the next tank, gas runs out early
  • Engine switches to its other fuel or reduced power

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2A94

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication