OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A93

Alternative Fuel Tank Select Valve A Control Circuit Low

P2A93 is stored when the module measures a voltage on the control line of tank select valve A that falls short of the level expected for the commanded state. With a low-side driver this usually means the line touches ground, which can energise the solenoid permanently and keep valve A in its switched position regardless of the command. If the valve is fed from the positive side instead, the same fault overloads that output, which then usually switches itself off. In both cases the module can no longer choose the vessel, so the automatic change from an empty tank to a full one, as described in Westport's two-vessel patent, cannot be relied on. Valves near cryogenic lines collect condensation, so water in the connector is a plausible cause. No manufacturer documents P2A93; P2A94 is the high case.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 93

Possible causes

  • Control wire of valve A chafed through to ground high
  • Condensation or water in the connector of valve A medium
  • Shorted turns in the coil of valve A low

Symptoms

  • Malfunction lamp on
  • Tank selection stuck, one vessel emptied completely
  • Fuse or output protection of the gas module trips

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2A93

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication