P2A8C
Alternative Fuel Vaporizer B Performance
P2A8C flags vaporizer B as underperforming: the gas leaving it is colder, or less completely vaporized, than the module expects for the current flow. With LNG the temperature gap is extreme, and Westport's patent CA2862664C describes the typical failure. At a cold start, at idle or under light load coolant crawls through the exchanger and can freeze inside it; flow then drops without stopping entirely, vaporizer capacity falls and the downstream gas temperature sinks, which can harm later components. Westport therefore runs fuel and coolant in parallel flow during start and idle and switches to counter flow afterwards. A stuck switching valve or ice can thus cause P2A8C. No manufacturer publishes the code or its limits.
Possible causes
- Coolant partly frozen inside vaporizer B after cold start or long idling high
- Valve that switches between parallel and counter flow stuck medium
- Low coolant level or too little antifreeze in the mixture medium
- Deposits reducing heat transfer in vaporizer B low
Symptoms
- Malfunction lamp on
- Reduced power or gas mode blocked, especially when cold
- Ice on the vaporizer or gas lines behind it
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2A8C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.