P2A8A
Alternative Fuel Pump C Compression Stroke Valve Control Circuit High
P2A8A indicates that pump C's compression stroke valve circuit sits higher than the commanded state allows, from an open coil, a broken wire or a short to the supply rail. The solenoid cannot shift the spool, which stays in the drain position, and element C never starts a compression stroke. Unlike the low fault P2A89, nothing stays pressurised; the element is simply missing from the firing sequence, which the controller covers by firing the remaining ones more often. When P2A8A appears together with P2A82 or P2A86, a shared supply or ground for all valves is more likely than three failed coils. No manufacturer documents P2A8A. Check the common feed and ground before replacing valve C.
Possible causes
- Open coil or broken wire at valve C high
- Fault in the supply or ground shared by the pump valves medium
- Control wire shorted to the supply rail low
Symptoms
- Warning lamp on
- Uneven gas pressure at high load
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A8A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.