P2A86
Alternative Fuel Pump B Compression Stroke Valve Control Circuit High
P2A86 is stored when pump B's compression stroke valve circuit shows a higher voltage than its state allows, pointing to an interrupted coil, a broken return wire where the valve is switched on the ground side, or a short to the supply. The valve then rests in its drain position: drive oil bypasses pump B and its plunger stays retracted. On a two-tank layout as in Westport's patent, the controller may keep drawing from the other tank, so the truck runs on while the second tank's LNG cannot be used and slowly warms up. Because the pump performs no strokes, its usual hydraulic pressure signature disappears, which helps to confirm the diagnosis. No manufacturer documents P2A86. Check the coil, the plug and the supply feed.
Possible causes
- Open coil or broken wire at valve B high
- Control wire shorted to supply voltage medium
- Corroded terminals in the valve B plug low
Symptoms
- Warning lamp on
- One LNG tank is no longer emptied
- Shorter range on gas
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A86
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.