P2A85
Alternative Fuel Pump B Compression Stroke Valve Control Circuit Low
P2A85 means the drive output for pump B's compression stroke valve reads too low for its commanded state. Typical are a control wire chafed through to the frame, which can keep the solenoid energised even when the controller wants it off, or a coil with shorted windings that draws excessive current. A valve stuck in the fill position leaves pump B's plunger parked at full extension; the pump stops delivering, and pressurised oil remains on its drive side. Caterpillar's six-element example can partly make up for this with the remaining elements, whereas a two-tank system loses the second tank's supply. No manufacturer publishes P2A85. Compare the measured coil resistance with that of an identical A or C valve.
Possible causes
- Control wire of valve B chafed through to the frame high
- Coil of valve B with shorted windings medium
- Output stage for valve B shorted low
Symptoms
- Warning lamp on
- Pump B delivers nothing, reduced power or range
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A85
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.