OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A82

Alternative Fuel Pump A Compression Stroke Valve Control Circuit High

P2A82 shows the drive line to pump A's compression stroke valve at a higher level than the commanded state permits, most likely because the coil winding or its wire is broken where the valve is switched to ground, or because the line touches battery voltage and the output stage loses control of it. The solenoid then cannot move the spool into the fill position, so oil never reaches the drive side and pump A performs no compression stroke at all. Gas pressure downstream of the pump sinks faster than the controller expects, and on a single-element system the engine soon runs short of fuel. Caterpillar's patents show the spool going back to drain when the solenoid is de-energized, which is the state this fault produces. No manufacturer publishes P2A82. Measure coil resistance and feed voltage.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 82

Possible causes

  • Open coil or broken wire at valve A high
  • Control wire shorted to battery voltage medium
  • Corroded valve connector low

Symptoms

  • Warning lamp on
  • Falling gas pressure and power loss
  • Engine may stall on gas with a single pump element

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2A82

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication