P2A81
Alternative Fuel Pump A Compression Stroke Valve Control Circuit Low
P2A81 is stored when the control circuit of pump A's compression stroke valve sits lower than the commanded state allows. With a low-side driver this mostly points to the control wire touching ground, which can energise the solenoid permanently; with a high-side driver a coil with shorted turns or a grounded feed pulls the output down until its protection trips. A valve held in the fill position keeps oil on the drive side, so the plunger cannot retract and refill, and pump A stays parked at full travel. In Caterpillar's six-element layout the remaining elements may cover part of the demand. No manufacturer publishes P2A81. Disconnect the valve and test the control wire for continuity to chassis ground.
Possible causes
- Control wire of valve A shorted to ground high
- Shorted turns in the solenoid coil medium
- Water in the valve connector low
Symptoms
- Warning lamp on
- Pump A stops delivering, power drops at high load
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A81
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.