P2A80
Alternative Fuel Pump A Compression Stroke Valve Control Circuit Range/Performance
P2A80 concerns the compression stroke valve of pump A when its circuit is intact but the outcome of a command does not match. In the patented multi-element design, the time the solenoid holds the spool in the fill position sets the stroke, and a shorter command yields a partial stroke; the controller therefore expects a defined gain in gas pressure or hydraulic load per activation. If pump A contributes clearly less than its partners, or the spool reacts late, a sticking spool, varnished oil or a weak return spring are likely. Caterpillar also stresses that hydraulic pressure during the stroke must be held within tight limits to keep the LNG from vaporizing. No manufacturer publishes P2A80 or its test.
Possible causes
- Spool of valve A sticking or slow high
- Contaminated or varnished hydraulic oil medium
- Weak return spring in the valve low
Symptoms
- Warning lamp after several drive cycles
- Uneven gas pressure and slight power loss
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2A80
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.