P2A7F
Alternative Fuel Pump A Compression Stroke Valve Control Circuit/Open
Hydraulically driven LNG pumps use solenoid valves to admit high-pressure oil to the drive side for the compression stroke and to vent it again for refilling. Caterpillar's patent US10060421B2 gives each of its six pumping elements, other counts being possible, a solenoid pilot that moves a spool between fill and drain positions; the controller sets timing and length of every stroke this way. P2A7F reports that pump A's compression stroke valve has an open or otherwise faulty control circuit. The valve then stays in its spring position and pump A no longer delivers. Which element or tank pump carries the letter A is not published, and neither is P2A7F itself. Check coil resistance and connector first.
Possible causes
- Open wire or loose connector at valve A high
- Solenoid coil of valve A burnt open medium
- Output stage in the control module faulty low
Symptoms
- Warning lamp on
- Reduced LNG delivery and lower power
- Gas pressure drops under load
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A7F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.