P2A7E
Alternative Fuel Hydraulic Pressure Sensor Circuit Intermittent/Erratic
P2A7E flags a hydraulic pressure sensor signal that breaks up or spikes briefly, then recovers before the low or high checks of P2A7C and P2A7D mature. Pressure in a pump drive pulses with every stroke anyway, so the controller has to tell genuine pressure swings from electrical noise; what it treats as erratic is a change faster than the hydraulics can produce, or a signal vanishing between strokes. Cold, damp surroundings close to the cryogenic tank, loose terminals and wiring rubbing on hydraulic hoses are typical causes. As long as the fault comes and goes, fuel delivery usually continues, but stroke timing may wander. No manufacturer documents P2A7E. Record the signal while moving the harness and compare it with the P2A75 sensor trace.
Possible causes
- Loose terminal in the sensor connector high
- Wiring rubbing on hydraulic hoses medium
- Condensation or ice near the cryogenic tank medium
Symptoms
- Warning lamp that comes and goes
- Uneven pump cycling or brief power dips
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A7E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.