OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A7C

Alternative Fuel Hydraulic Pressure Sensor Circuit Low

P2A7C is set when the hydraulic pressure sensor signal falls below its valid band, most often from a signal wire grounded against the chassis, an open 5 V reference or a sensor with an internal short. If this sensor watches the return side, as in one of Caterpillar's layouts, a dead-low reading would hardly stand out at first, since return pressure is low anyway; the range check against the minimum voltage still catches it. On the drive side a low value can mask the pressure rise that marks a completed stroke. The control may then rely on the remaining sensor or stop the LNG pump. Where both pressure sensors share a reference wire, check whether P2A77 is stored too. No manufacturer documents P2A7C or its thresholds.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 7C

Possible causes

  • Signal wire grounded against chassis or hydraulic lines high
  • Open 5 V reference to the sensor medium
  • Sensor shorted internally low

Symptoms

  • Warning lamp on
  • Pump stops or delivers less LNG
  • Additional sensor codes if the reference is shared

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2A7C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication