P2A79
Alternative Fuel Hydraulic Pump Pressure Sensor Circuit Intermittent/Erratic
P2A79 records a hydraulic pump pressure signal that jumps or drops out for short moments without staying low or high long enough for P2A77 or P2A78. In a reciprocating LNG pump the controller reads this sensor continuously to find each stroke end, so a single spike can be mistaken for the end of travel and a brief dropout for a missing pressure peak. The pump may then run uneven strokes, and Westport's empty-tank logic, which counts low peaks over several strokes, can be misled. Vibration at the frame-mounted hydraulic unit, moisture in the plug and fractured crimps are typical causes. No manufacturer documents P2A79. Log the signal while flexing the harness; dropouts in an otherwise steady trace point to wiring.
Possible causes
- Loose or fractured crimp terminal in the sensor circuit high
- Moisture or ice in the sensor plug medium
- Harness damaged by vibration at the hydraulic unit medium
Symptoms
- Uneven fuel pressure or surging power on gas
- Sporadic warning lamp that clears again
- Occasional false empty-tank message
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A79
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.