P2A78
Alternative Fuel Hydraulic Pump Pressure Sensor Circuit High
P2A78 indicates that the hydraulic pump pressure sensor reports a voltage above its plausible maximum, as happens when the signal line touches the reference or battery voltage or the sensor ground is open. A false high reading is critical for the pump cycle, because rising oil pressure is the usual cue that a stroke has ended: Caterpillar's patent US9228574B2 names this as the conventional way to reverse the drive. With a pinned-high signal the controller may reverse too early or halt the pump, and LNG delivery collapses. Westport's design also uses this sensor to spot abnormal conditions, so an over-range value cannot be trusted. No manufacturer publishes P2A78. Inspect the sensor ground and look for chafed wires.
Possible causes
- Sensor ground open or corroded at the connector high
- Signal wire shorted to reference or battery voltage medium
- Pressure sensor failed with output at full scale low
Symptoms
- Warning lamp and very short or no pump strokes
- Falling gas pressure and loss of power
- Engine switches to reduced power or stops on gas
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A78
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.