P2A74
Alternative Fuel Hydraulic Fuel Pump Select Valve Control Circuit Intermittent/Erratic
P2A74 covers brief, recurring faults in the select valve control circuit that clear before a firm low or high verdict. On LNG trucks the valve usually sits near the tank-mounted pump and hydraulic lines, where frame flex, road spray and very cold surfaces around the cryogenic tank stress connectors and insulation. A valve that drops out for a moment can cut hydraulic flow to the working pump mid-stroke; because Westport's control logic recognises the stroke end from pressure changes, such dropouts may also upset pump timing. Typical finds are loose terminals, corroded pins and wiring chafed along the frame rail. No manufacturer publishes P2A74. Wiggle the harness while watching the output status, and check the plug for moisture.
Possible causes
- Loose terminal in the select valve connector high
- Moisture or ice in the connector near the cryogenic tank medium
- Harness chafed along the frame rail with intermittent contact medium
Symptoms
- Check engine light on, may go out again
- Brief hesitation or pressure dips in gas mode
- Irregular tank changeover
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A74
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.