P2A73
Alternative Fuel Hydraulic Fuel Pump Select Valve Control Circuit High
P2A73 signals that the select valve control circuit sits at a higher voltage than the commanded state allows. Typical faults are an open coil or broken wire on a low-side driven valve, which leaves the line at supply voltage, or a short to battery voltage that the output cannot pull down. The valve then stays in its spring-return position, so hydraulic flow keeps going to one tank pump whatever the command. On a multi-tank LNG truck the second tank may never be used, and the engine runs short of gas although LNG remains on board. Caterpillar's patent shows such a valve shifted by an actuator under controller command. No manufacturer publishes P2A73. Check coil resistance, the connector and the supply wire.
Possible causes
- Valve coil or control wire open high
- Control wire shorted to battery voltage medium
- Corroded connector pins with very high resistance low
Symptoms
- Check engine light on
- Second LNG tank not used, range clearly shorter
- Gas supply stops although fuel remains
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A73
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.