OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A6E

Alternative Fuel Rail Pressure Regulator Inlet Pressure Too Low

P2A6E is not a wiring fault: the inlet pressure sensor works, but the gas reaching the regulator is too weak for it to hold rail pressure. A regulator can only reduce pressure, so once the supply approaches its outlet setpoint, rail pressure sinks with it. ITT's CNG regulator patent addresses exactly this low-supply phase with a bypass that opens below a set inlet pressure. Common reasons are a nearly empty cylinder, a tank solenoid or manual valve that is not fully open, or a clogged high-pressure filter. Ford's 2003 bi-fuel CNG system closed the tank valve and fell back to petrol once system pressure dropped under 517 kPa (75 psia). No manufacturer publishes P2A6E; refuel first, then compare inlet pressure with a gauge.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 6E

Possible causes

  • Gas cylinder nearly empty high
  • Tank solenoid or manual shut-off valve not fully open medium
  • High-pressure filter clogged or line restricted medium
  • Inlet pressure sensor reading too low within its range low

Symptoms

  • Check engine light on
  • Loss of power or stumbling in gas mode, especially at high load
  • Automatic switch to petrol or engine stalls on dedicated gas engines

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2A6E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication