P2A6D
Alternative Fuel Rail Pressure Regulator Inlet Pressure Sensor Circuit Intermittent/Erratic
P2A6D is the dropout code of the regulator inlet pressure sensor: the signal jumps or briefly vanishes, but not long enough for a steady low or high verdict. The regulator normally lives in the engine bay, next to the right-hand strut mount on GM's 2015 Impala bi-fuel, and Blackstone requires warm engine coolant to circulate through its SAN209 unit so that it does not ice up. Its connector therefore sees heat, vibration and condensation. Loose terminals, a harness chafed against coolant hoses or moisture inside the plug are the usual suspects. No manufacturer publishes P2A6D; CARB expects circuit faults of such inputs to be detected. Wiggle-test the harness while watching live data, and look for corrosion in the connector.
Possible causes
- Loose or widened terminal in the sensor connector high
- Condensation or corrosion in the plug near the coolant-heated regulator medium
- Harness rubbing on hoses or brackets with intermittent contact medium
Symptoms
- Check engine light on, sometimes clearing again
- Gas gauge flickers or jumps
- Sporadic switch from gas to petrol while driving
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2A6D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.