OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A6B

Alternative Fuel Rail Pressure Regulator Inlet Pressure Sensor Circuit Low

P2A6B is stored when the signal voltage of the regulator inlet pressure sensor drops below its valid band. With a typical three-wire transducer (5 V feed, signal, ground) that means a signal lead shorted to ground, a lost 5 V reference or a failed sensor element. A low voltage would read as an almost empty cylinder, so a bi-fuel vehicle may refuse gas mode or show an empty gauge with a full tank; Ford's 2003 bi-fuel CNG logic drove the gauge to empty whenever the sensor built into its regulator failed. GM uses the same reading on the Impala together with tank temperature to work out the fill level. No maker publishes P2A6B directly. Measure feed and signal at the plug with the key on before condemning the sensor.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 6B

Possible causes

  • Signal wire chafed through and shorted to ground high
  • 5 V reference open or pulled down by another sensor on the same feed medium
  • Inlet pressure transducer internally shorted medium

Symptoms

  • Check engine light on
  • Gas gauge shows empty although the tank is full
  • Gas mode refused, bi-fuel vehicle runs on petrol

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2A6B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication