P2A69
Alternative Fuel Rail Pressure Regulator Inlet Pressure Sensor Circuit
On a gaseous-fuel engine, the rail pressure regulator takes gas straight from the storage cylinders and steps it down for the injector rail. P2A69 covers the transducer on the high-pressure side of that regulator, set when its circuit is faulty without a clear low or high verdict. GM's 2015 Impala bi-fuel mounts a three-wire sensor on top of the regulator that reads cylinder pressure as high as 3,600 psi; Ford's 2003 bi-fuel CNG trucks build it into the regulator. ITT describes a CNG regulator with a transducer at its inlet port next to one at the outlet. None of them publishes P2A69 itself. Without the reading, remaining gas and regulator supply cannot be judged, so gas mode is usually blocked. P2A6B and P2A6C name the low and high cases.
Possible causes
- Connector or harness at the regulator damaged by heat, vibration or corrosion high
- Inlet pressure transducer on the regulator faulty medium
- 5 V reference or sensor ground disturbed medium
- Engine or alternative fuel control module faulty low
Symptoms
- Check engine light on
- Gas mode not available, bi-fuel vehicle stays on petrol
- Gas gauge implausible or showing empty
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2A69
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.