OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A62

Alternative Fuel Tank B Level Sensor Circuit High

P2A62 is set when the tank B level signal climbs above the highest voltage a working sender delivers at full. For its dual-tank propane trucks Roush blames the high case on a disconnected sender or a wire shorted to more than 5 V, and with the second-tank code P2068 the gauge again falls back to the primary tank only. A broken ground at the sender gives the same picture on most pull-up inputs. The risk is the opposite of P2A61: if the reading were accepted, tank B would look full while it empties, so the module discards it. No manufacturer documents P2A62 itself. Check that the plug at the tank B sender is seated and locked, then test ground continuity before replacing the sender.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 62

Possible causes

  • Tank B sender unplugged or wire open high
  • Sender ground interrupted medium
  • Signal wire shorted to a voltage above 5 V low

Symptoms

  • Check engine light
  • Gauge shows only the primary tank
  • Content of tank B unknown to the driver

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2A62

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication