P2A5D
Alternative Fuel Vaporizer C Outlet Temperature Sensor Circuit High
P2A5D says the vaporizer C sensor signal is stuck high, near the reference voltage, which reads as extreme cold. An interrupted wire, a disconnected or corroded plug, an open sensor or a short to battery voltage are the candidates. Gas controllers that use vaporizer temperature as a release condition, as AC STAG does before switching to gas, will hold off gas mode when they see such a value. With two other vaporizers still reporting, a control unit might be calibrated to carry on without C at reduced output, but no manufacturer documents P2A5D or its reaction. TransEco's analogous rail temperature High code names an open sensor or short to power. Measure resistance at the sensor and compare it with the coolant temperature.
Possible causes
- Wire to sensor C interrupted or plug disconnected high
- Sensor C open inside medium
- Signal lead shorted to battery voltage low
Symptoms
- Check engine light, depending on calibration
- Gas mode held back or output reduced
- Vaporizer C shown at extreme cold
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2A5D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.