P2A5C
Alternative Fuel Vaporizer C Outlet Temperature Sensor Circuit Low
P2A5C stands for a vaporizer C outlet signal below the valid range. Since such inputs are normally NTC thermistors, the module would read an implausibly hot unit; a signal lead touching ground or a sensor shorted internally is far more likely. Coolant that has seeped into the connector can also create a path to ground. AC STAG controllers show this as a short in the reducer temperature circuit and advise checking insulation and plug. A wrongly hot vaporizer C is a safety concern, since gas could pass through a unit that is in fact too cold to vaporize it fully. No manufacturer documents P2A5C. Disconnect the sensor and watch the value: a jump to cold means the sensor itself is shorted, no change means the fault sits in the wiring.
Possible causes
- Signal lead of sensor C shorted to ground high
- Coolant or water in the connector medium
- Sensor C shorted inside medium
Symptoms
- Check engine light, depending on calibration
- Gas operation blocked or limited
- Vaporizer C shown far too hot
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2A5C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.