P2A58
Alternative Fuel Vaporizer B Outlet Temperature Sensor Circuit High
Here the signal of the vaporizer B outlet sensor rests at or near the reference voltage, so the module would see a deep-frozen unit. Typical reasons are an open wire, a plug that has backed out, a sensor element that has failed open or a short to a supply line. Telling a wiring fault from a real problem matters on gas engines: CA2862664C warns that coolant inside and next to an LNG heat exchanger may turn to ice during a cold start, and such a frozen vaporizer would also read very cold, though not at the electrical limit. The control unit therefore stops trusting vaporizer B, which can mean reduced gas delivery or a fall-back fuel. AC STAG calls the open case a missing sensor. No manufacturer documents P2A58.
Possible causes
- Open wire or plug of the B sensor backed out high
- Vaporizer B sensor element open medium
- Signal lead touching a supply line low
Symptoms
- Check engine light, depending on calibration
- Gas delivery reduced or fall-back fuel used
- Vaporizer B shown at an impossibly low temperature
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2A58
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.