P2A57
Alternative Fuel Vaporizer B Outlet Temperature Sensor Circuit Low
P2A57 sets when the outlet sensor on vaporizer B pulls its signal below the lowest valid voltage. On a thermistor that loses resistance with heat, as in the Ford CNG rail sensor, this would mean extreme heat, so the realistic causes are a signal lead grounded against the chassis and an internally shorted sensor. Long harness runs, common when the gas parts sit far from the controller, add chafing points. A falsely hot value is risky because the system could believe B is ready while it is cold. TransEco, for its comparable rail sensor fault, substitutes the intake air reading on dedicated systems and forces petrol on bi-fuel ones. No maker lists P2A57. Unplug the sensor: the reading must swing to cold, otherwise the harness is shorted.
Possible causes
- Signal lead of the B sensor grounded high
- Vaporizer B sensor shorted internally medium
- Insulation worn through on a long harness run low
Symptoms
- Check engine light, depending on calibration
- Gas operation limited or switched off
- Vaporizer B shown far hotter than vaporizer A
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2A57
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.