OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A53

Alternative Fuel Vaporizer A Outlet Temperature Sensor Circuit High

P2A53 is the opposite case: the voltage of the vaporizer A outlet sensor sits near the supply reference, which a thermistor input reads as extreme cold. A broken wire, an unplugged or corroded connector, an open sensor element or a short to a voltage source all produce this. AC STAG names the open variant a missing reducer temperature sensor. Because its controllers only change over to gas once the reducer temperature allows it, such a reading keeps a bi-fuel vehicle on petrol; a dedicated gas engine may refuse to start or run with reduced output. TransEco handles the related rail sensor High code the same way, forcing petrol mode with the lamp on. No manufacturer publishes P2A53 itself. Bridging the plug pins should make the value jump to very hot.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 53

Possible causes

  • Wire broken or connector unplugged high
  • Sensor element open inside medium
  • Signal wire shorted to a voltage source low

Symptoms

  • Check engine light, depending on calibration
  • No switch-over to gas, bi-fuel vehicle stays on petrol
  • Live data shows a vaporizer far below freezing

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2A53

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication