P2A52
Alternative Fuel Vaporizer A Outlet Temperature Sensor Circuit Low
Temperature sensors of this type are usually thermistors whose resistance falls as they get warmer, the same principle Ford describes for the fuel rail sensor of its 2003 bi-fuel CNG trucks. A signal under the lower limit would therefore mean an impossibly hot vaporizer A; in practice the signal line touches ground or the sensor is shorted inside. AC STAG lists this case as a reducer temperature sensor short. The danger is that a hot reading could let gas flow into a unit that is actually cold, so a control module will normally replace the value or fall back to petrol. No manufacturer documents P2A52. Pull the plug and watch the live data: a swing to very cold clears the harness, a hot value that remains points to a short in the wiring.
Possible causes
- Signal wire shorted to ground high
- Sensor shorted internally medium
- Moisture or coolant in the connector low
Symptoms
- Check engine light, depending on calibration
- Gas mode blocked, vehicle runs on petrol
- Live data shows an implausibly hot vaporizer
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2A52
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.