P2A4E
Alternative Fuel Temperature Sensor Circuit High
The counterpart to P2A4D: the gas temperature signal rises above its upper limit. With the usual NTC thermistor fed through a pull-up resistor, that equals an absurdly cold reading, and the most frequent reason is an open circuit, either a broken wire, a loose terminal or a sensor that has gone open inside. A short to a voltage source has the same effect. In TransEco's list the related rail temperature High code is attributed to exactly these causes and handled like the Low case, with a substitute value from the intake air sensor or a forced change to petrol. No manufacturer documents P2A4E publicly. Bridging the two pins at the plug should flip the reading to very hot; if not, the break lies between plug and module.
Possible causes
- Broken wire or loose terminal in the sensor circuit high
- Thermistor open internally medium
- Signal wire shorted to a voltage source low
Symptoms
- Check engine light
- Live data shows gas temperature at its coldest limit
- Bi-fuel vehicle falls back to petrol
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2A4E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.