P2A49
Alternative Fuel Tank C Pressure Sensor Circuit High
P2A49 is the mirror image of P2A48: the tank C pressure signal sits above the band a healthy sensor uses, so the module rejects it. In TransEco's AFCM table the tank A equivalent traces back to a sensor with an open circuit or a short to the supply. An open ground is a classic trigger too, because the input is then pulled toward its supply rail. The practical danger is a cylinder that seems full when it is not; the gauge stays high and the system may count on gas from tank C until the engine starts to falter on a near-empty supply. No manufacturer lists P2A49 publicly. With the system depressurised and the plug off, check whether the voltage at the module side still reads high; if so, the fault lies in the harness rather than the sensor.
Possible causes
- Ground or signal wire of the tank C sensor interrupted high
- Signal shorted to 5 V or battery voltage medium
- Tank C sensor open internally medium
Symptoms
- Check engine light
- Gauge for tank C stays at full
- Hesitation once tank C really runs low
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A49
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.