P2A48
Alternative Fuel Tank C Pressure Sensor Circuit Low
With P2A48 the voltage from the tank C pressure sensor has fallen beneath the lowest value a working sensor ever outputs, even with the cylinder empty. In such three-wire circuits a low reading points to the signal line touching ground, a dead 5 V supply or a short inside the transducer. The gas conversion specialist TransEco attributes its tank A Low code to a sensor shorted to ground and lets the AFCM continue with a fixed 3600 psi substitute while the lamp is on. For the driver, tank C looks drained: the gauge may sink and the module may skip that cylinder although it is still full. No manufacturer documents P2A48 itself. If the reference wire also feeds other sensors, a short elsewhere on it can trigger this code.
Possible causes
- Signal wire of the tank C sensor touching ground high
- 5 V reference open or shorted by another sensor on the same line medium
- Internal short in the tank C transducer medium
Symptoms
- Check engine light
- Tank C reported empty despite being filled
- Less gas range than expected
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A48
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.